225° for 4 hours and 250° for 30 minutes


 
K

Ken B

New member
I'd say that this is dialed in.... Primo XL with maple leaf charcoal. I was cooking baby back ribs and this was the graph of the cook with the HeaterMeter and MicroDamper. #blownaway

I had the HM set so that below 25% I'm damper only, so this show the strength of the Primo as well as the HeaterMeter but the HeaterMeter is there to deal with anything that happens through the cook.

image_zpsjng0s1gx.jpeg
 
So you had the MicroDamper set to run fan only above 25%, and the servo to run the full range of motion? Also, could you post up your PID values for others to use in the future?
 
Ya, I should have been more specific. Fan "on above" was 25% so much of the steady state was damper only.

P = 4, I = 0.003, D = 4.
 
One last question. Was your min fan at 0% or 25%?

I'm going to take a guess and say it was 0%. Because when the fan did kick on you had a little bit of a spike - though pretty small.

Great looking cook!
 
You must log in or register to reply here.

 

Back
Top