22 WSM garage door handles?

[John Segura]

So I'm interested in making a work table, just like the one listed here http://virtualweberbullet.com/worktable.html (the one by Brian M.). I ordered the genie garage door handles (clones) and they don't fit my 22. So are there any out there that work or any other suggestions to accomplish this? Thanks!

 

[Bob Ivey]

I got those from Lowe's and they don't line up directly. After looking at a number of posts about these handles, it looks like two bends are required on each side of the handle. The first will spread them to acommedate the hole spacing and the and the second is to flatten the surface for mounting to the cooker. I wound up making the brackets like the existing handles and ordering the same plastic handles that are stock on the cooker. I am just using the table of my Performer. That or using a separate small table. Good luck.

 

[Dwain Pannell]

I got those from Lowe's and they don't line up directly. After looking at a number of posts about these handles, it looks like two bends are required on each side of the handle. The first will spread them to acommedate the hole spacing and the and the second is to flatten the surface for mounting to the cooker.

This is what I did.

 

[David]

I saw the post by Brian but wanted handles in the horizontal position so I somewhat knocked off Brian's idea and did them this say. My intent was to have the ability to take off and on, but I've yet to take them off since assembly.......http://tvwbb.com/showthread.php?39419-My-side-table-mod-maybe-last-mod-but-doubtful

David