probe

I just received my new HeaterMeter, whoohoo. I had a few issues with the case. Have you ever put something together but couldn't fine a nut to screw it together? That happened to me the nut kept falling out of the slot in the case. I vacuumed, used a magnet even got out my metal detector, still...

Is there a way to change the probe that is in control? I have a 4.3 board with built in thermocouple circuit running the latest snapshot and would to change the probe that is in control. Thanks

Hello, Let me start by introducing myself... I'm Tom, live in Belgium and found this nice forum after researching "pit controllers" I'm planning on building a couple of HM myself in the near future. Just waiting on the boards to arrive by slow boat from China... All the electronics are waiting...

Situation: Heatermeter pit probe reading = 225°F BGE pit thermometer reading = 165°F Approximately 60°F off. Configuration: Preset=TX-1001X-OP Resist=10000 Offset=0 I have the ThermoWorks TX-1003X-AP (thermistor). Questions: Is having a 60°F offset reasonable for the configuration? Should I do...

I just bought a Maverick ET733, and connected the two probes. The receiver is working (both registering the same ambient temp). My question is about the alert. If I press the ((*)) button at the lower left one time, that symbol ((*)) appears in both probe windows on the right hand side...

Hi guys, This is my first real post here. I have searched for the topic, and didn't see the results. Hopefully I won't get yelled at for asking this, if it has been asked before and I missed it. Back on track: Where and how do you support your meat probe on your cooker? I have a maverick probe...