Jerry Allen
New member
I have had some issues with HM today. The 1st day of operation.
Hardware
Known good RPI 3b+
Known good sd card
Know good RF quality signal is great with 99% quality @72mbps, no dropped packets wile pinging
Power supply is 12v regulated 5 amp. the scope see little to no noise from the supply.
1. Serial Error and no HM hardware detected. Restarted linkmeterd and it worked. Did not require a reboot or power cycle of the PI, nothing logged that I can find.
2. Trying to use PitDroid all was working then poof it worked no more. Reset my phone, reinstalled pitdroid still no go but a browser pointed at the same ip/port would work. I reboot the HM and PitDroid started working. All the while I have an external process that I built for another grill controller that is polling the new HM every 30 seconds so I can get it integrated and that process never missed a polling set.
I have remote logging turned on and there is nothing logged about the serial error or about this inability to connect.
Any suggestions? I will put this on a battery to eliminate power issues.....
Jerry
Hardware
Known good RPI 3b+
Known good sd card
Know good RF quality signal is great with 99% quality @72mbps, no dropped packets wile pinging
Power supply is 12v regulated 5 amp. the scope see little to no noise from the supply.
1. Serial Error and no HM hardware detected. Restarted linkmeterd and it worked. Did not require a reboot or power cycle of the PI, nothing logged that I can find.
2. Trying to use PitDroid all was working then poof it worked no more. Reset my phone, reinstalled pitdroid still no go but a browser pointed at the same ip/port would work. I reboot the HM and PitDroid started working. All the while I have an external process that I built for another grill controller that is polling the new HM every 30 seconds so I can get it integrated and that process never missed a polling set.
I have remote logging turned on and there is nothing logged about the serial error or about this inability to connect.
Any suggestions? I will put this on a battery to eliminate power issues.....
Jerry