Recently got a Auberins for my 18.5" WSM. Here is the issue.
On the last two cooks, once I get it dialed in and everything is going good, after 1.5 hrs or so,
the fan I guess starts blowing harder to keeps temperature up and then blows flame out, so to speak.
I then unplug fan and open a vent at bottom and temperature will rise back up to my set point.
Plug it back in and then after a short while, it will start all over again.
Tried closing top vent to half or less, just to see if that would help, but no luck.
Should I bank briquettes higher at fan side to deflect blowing. FYI: I do start coals opposite side of fan.
Any suggestions?
THANKS
On the last two cooks, once I get it dialed in and everything is going good, after 1.5 hrs or so,
the fan I guess starts blowing harder to keeps temperature up and then blows flame out, so to speak.
I then unplug fan and open a vent at bottom and temperature will rise back up to my set point.
Plug it back in and then after a short while, it will start all over again.
Tried closing top vent to half or less, just to see if that would help, but no luck.
Should I bank briquettes higher at fan side to deflect blowing. FYI: I do start coals opposite side of fan.
Any suggestions?
THANKS