Andrew Meimann
TVWBB Member
I have a LinkMeter with a V3.2 HeaterMeter board. I built this last spring and have not upgraded since. This morning I upgraded HeaterMeter through the LinkMeter web interface. HeaterMeter upgraded successfully and the LCD shows the correct temps of 4 different probes. After the upgrade the web interface lost all of the settings in the configuration page and the home screen does not show any information. It is also painfully slow to open the web interface now. I decided to try to upgrade LinkMeter and am have having some issues. When I try to upgrade using PuTTY and following the instructions in the wiki I get the following:
root@ACMLinkMeter:~# sysupgrade http://capnbry.net/linkmeter/snapshots/trunk/lin
kmeter-brcm47xx-squashfs.trx
Saving config files...
Sending TERM to remaining processes ... dnsmasq ntpd syslogd klogd hotplug2 lua
Sending KILL to remaining processes ...
Switching to ramdisk...
Performing system upgrade...
wget: bad address 'capnbry.net'
wget: bad address 'capnbry.net'
Could not get image header, file too small (0 bytes)
Image check failed.
Upgrade completed
Rebooting system...
After the reboot the web interface is still painfully slow to access, and it does not show any information from HeaterMeter (which still works fine). Can someone point me in the right direction? Thanks
root@ACMLinkMeter:~# sysupgrade http://capnbry.net/linkmeter/snapshots/trunk/lin
kmeter-brcm47xx-squashfs.trx
Saving config files...
Sending TERM to remaining processes ... dnsmasq ntpd syslogd klogd hotplug2 lua
Sending KILL to remaining processes ...
Switching to ramdisk...
Performing system upgrade...
wget: bad address 'capnbry.net'
wget: bad address 'capnbry.net'
Could not get image header, file too small (0 bytes)
Image check failed.
Upgrade completed
Rebooting system...
After the reboot the web interface is still painfully slow to access, and it does not show any information from HeaterMeter (which still works fine). Can someone point me in the right direction? Thanks