Search results

Hey all, I've been in the process of building a 250 gallon reverse flow smoker mounted on a trailer. As part of the project, I will be designing a 3D printed fan/servo combo that I will make available to everyone once completed. The part I'm stuck on is what fan to go with. Questions I have that...

https://www.kickstarter.com/projects/1977846026/meater-the-first-truly-wireless-smart-meat-thermom?ref=project_link Bryan, any chance of hacking this someday to make a smaller HM that gets its temp readings from this and then just controls a servo/fan?

As you all are well aware, the HM project has evolved over the last few years to a point where 3D printing has become an integral part of the community. When this first started the demand wasn't very high and Matt and I were able to handle most requests. As you might have heard, due to time...

This is a nice write up by a former bell labs physicist who happens to love bbq. http://www.huffingtonpost.com/craig-goldwyn/physicist-cracks-bbq-mystery_b_987719.html

Here is the newest release of the Heatermeter 3D printed case to complement the 4.2.4 boards. We've tried to push the design forward to parallel some of the tremendous progress that Bryan has made with the new boards. This case went through many behind the scenes revisions and we must thank...

Last night I started a cook with my new HM 4.1. I was running in fan and servo mode over cat5 and started getting some very strange behavior. I initially had the fan and servo both operating together with fan from 10 to 100%. At first everything was ok, the pit was stoking at 100% and I was...

Here is the new 3D printed case for the v4.1 boards. Overall, the case is slightly smaller and more snug than the previous versions. Since there is a lot more freedom now for screw placement, we set them slightly inwards to keep the holes away from the corners which should help prevent curling...

I'm updating this thread to reflect a few observations that I've made regarding the servo dampers. The barrel servo has worked well for me, but in the last few months I have found that the rotary valve design is much easier to print and probably works even better. I will leave the barrel servo...

Just trying to send a message to Kilkenny. You have been PM'ing Matt and I about a case but have not registered on the board so we can't reply to your messages. Send me your email address. I apologize to everyone for starting a thread for this but I couldn't figure out another way to get a...

This thread is for discussion and updates of the Heatermeter v4 with raspberry pi 3D print case. The source files were created in autodesk123d and can be found below. You can PM me or Matt (M Miller) to purchase a case. Available colors are: black, red, ivory/white, silver, orange, blue, green...

I ran into a situation today during a cook where my linkmeter continued to show the realtime probe values but stopped graphing the data. It just continually showed the scrolling progress meter. I restarted the browser a number of times but the only way I got it back was to hard reset the...

I thought it might be a good idea to start a thread for the different fan/cooker setups people have been using with temperature ranges that have been attained. I have a large BGE and am using the auber 6.5 cfm fan. Specifications: Power source 12 VDC, 3W Cable length 4.5 ft (1.5 M) Electric...

I started this thread as per Bryan's request for discussing problems as new topics. I put together my heatermeter by following the schematics and reading many of the posts by all of the contributers on this site. I did not include the parts required for wireless probe assembly and installed the...