Search results

i got pm emailed you back

Are you planning to testing in the near future? Please PM me and I will try and get it assembled and will start some testing.

i am looking for this on Osh park could not find it do you have a link? how about schematic for it?

Anyone have time to try and make a x3 board tried playing with eagle but my old laptop can hardly run it without freezing up. I don't use conventional HeaterMeter case so mounting is no problem, I would use panel mount TC jacks.

I was hoping to do it cheaper.

Has anyone found a TC amp board or designed an add on board to add three more tc probes to the HM? Tired of the food probes failing on me. Dale

Yes all three have both latest hm and openwrt.

No only seems the first one I started up with latest software registered, other two don’t show even if started as the only one running.

That is what I thought maybe it can only register one per Internet IP. Even logged in from same network can not see all three. I can pull them up individual by their respective static IP I assigned to each within the network or by the port forwarding port I assigned to each of them.

I have 3 Heatermeters all of them on the web but only one of them shows on the heatermeter device page. Is there a trick to get more than one to show? to of them are the latest the other is the 4.1 all running latest software.

14 pound turkey for smokefied turkey Per Jack on Gratetv 2 hours smoke, ten minutes deep fry http://daleskeg.dyndns.org:6968 Second 14 pounder on 1st one into the oil

Thanks just what I was looking for!

Wondering is it is possible to have two separate lines on the home page to see both the blower and servo output, maybe with the servo showing 0 to 100 speed and a red line showing the limit speed set point ?

Did you try adjusting the pot, and check all you connections on the shift register?

http://daleskeg.dlinkddns.com:6968 10 pound butt on the Keg

Thanks I will set them the same or a little higher on "max"

HeaterMeter "startup mode" until the first time it reaches temperature. Is this every time the temp set point is changed? Or just after powering up? Since the trigger is changing the set point. I see a potential problem with how it is implemented. When doing a cook and you decide to increase...

I have carefully set my the the servo times and am no where near the servo limits and servos are not in a bind.

Chatter may be a better word for it, I guess it is not constant but is very frequent at least every 5 to 10 seconds I will try and time it tonight after work. I can hear it chattering from across the room.

Servos buzzing when stopped with three different HM's 1- 4.1 and 2 - 4.2 and three different manufactures of power supplies and two types of supply switching and transformer, two different different servos. Did not do it on the 4.1 until last software update. Both 4.2 buzzing as soon as...