Search results

Once I flashed the software to the SD card, put the card in the pi, and turned it on.. without changing anything I should have just been able to go to the web interface, click on network, wifi and click on scan? Or do I have to actually change the adapter from AP mode to client mode? I tried...

I've gone ahead and ordered the Edimax 150 Mbps one. Maybe I'm misreading the wiki for supported wifi adapters, the one I bought is tested & recommended for linkmeter v11, and recommended when wanting to run as wifi AP mode. I assumed that meant it would work for both modes? Not just AP mode?

Just finished my build. On the network-interfaces tab, the wireless adapter shows a mac address of 00:00:00:00:00:00. On the wifi tab, pressing scan doesn't bring up any wireless networks. I bought the 'Generic "niceEshop" 150Mbps with antenna' adapter, which should have the RT5370 chip...

Thanks, that's all I was looking for. 4.2

I'm specifically asking about the dedicated ground. Where do I jumper the ground to on the board, from the pin I choose to be ground on the RJ45 jack?

Ralph (or anyone else) On the HM board, where do you actually jumper the probe ground to, from the RJ45 jack pins? Over to pin4 ground for the servo/blower, or over to another ground on the board? eg over to the power jack ground? over to the pit probe ground?

Top right of this picture under the green wire (from an older build) https://plus.google.com/photos/+BryanMayland/albums/5614868070750159681/5783363463069416162?pid=5783363463069416162&oid=115791887386052258127

Yeah don't expect yours until next Tuesday.

Got it. Came in a soft sided purple bubble envelope. Surprised the board isn't in 3 pieces.

Thanks. USPS - Canada Post?

Customs trying to figure out if I'm building a bomb

Is anyone else here in Canada and had the shipping of the HM board from OSH Park take 2+ weeks? I received a shipping confirmation Tues July 29 and I still don't have the board, it's the only thing I'm waiting for.

I'd be switching to the hard stuff at that point

I'm good then, have it all

Oops yeah PCB from OSHPark is on order too. I have solder wick Not doing the thermocouple version, should I still have flux?

I've ordered: Case Damper Mouser project parts (except some that were backordered) Digikey parts (+Mouser backordered parts) Ambient thermistor MG90S servo RPi B Wifi Dongle (one of the tested ones) 12v power wallwart Already have: Several ET-72 food probes & ET-73 pit probes EMT fitting for...

I just got your message, and responded back.

Hi Ralph, I sent you an email a few days ago. Can you send me the files for the rotodamper? I'd like to get one printed (have a local source). I have a Broil King Keg and I am about to order the parts for the HeaterMeter. Thanks, Mike