Recent content by Ted F

No TC components, and the base board assembly went smoothly following the instructions, without any missing or spare parts. Tonight I re-soldered the components, wiped everything down with alcohol, and get the same wonky results for the pit probe and it is rock solid steady for probe ports 1-3...

Thanks, but I did check that. I made sure that all ports were set the same then tried the probe in each port, and consistently port 0 does the random high numbers, "no probe," and a stable reading, then occasionally the cycle repeats. I tried putting the soldering iron on the circuit...

I haven't been able to find the values required to configure the Weber probe under "custom," and plan on acquiring a Thermoworks probe eventually. The strange thing is that with all of the ports configured the same, the Weber probe has no problems and gives identical readings in ports 1-3 and...

Thank you very much for the reply. I checked the solder on all of the components and used alcohol and a soft toothbrush, then let it dry thoroughly. Unfortunately I get the same result after enabling port 0. I disabled port 0 and will try a cook in the next couple weeks, then see if I should...

Hi, I just finished building a HM 4.3 with a Pi Zero W that boots up with LEDs working, it connects to the network, and seems to work with the blower except for something wonky with the pit probe. I had intended to use my Maverick 732 probes with the HM (understanding they aren’t ideal), but...