Recent content by ShaneStemson

Ah I'll try that thanks Ralph

I have tried many times to connect to my phone via mobile hot spot is it possible and if how? thank you.

Just putting a shout out that I am going to use 2 heatermeters and 2 micro dampers t fire on ice world championships next weekend. want to see some uds pid and damper settings I am running p7 i.01 d4 and fan at 40 0min 100max startup50 servo 30% 1250-1900 running the 2 hot and fast at 300f...

need good start points for uds as well thank you.

got it connected and fan works but no servo.............

And thank you!!!

got it got it had a bad pad little work and a mag glass got it fixed. on too raspberry pi 3 wont connect any longer red led but no green...

Tried that also

Thanks for the help!!! I need it!

I have checked voltage and everything seems fine. As far as startup it will show no pit probe and read all probe temps but I cannot access any menus.

Powers up can't use any buttons not getting 3.3v out of le1 off of the chip. Got it to link via hard wire but now that does not work. I'm in over my head need help thanks in advance. Red led doesn't work either but think that is le1.

Called fire board drive has a dongle and a 20 cfm fan on there website but fireboard and the drive together is like 400 dollars

Check into a fire board it has 6 probes

Will the probes for the fire board work on the heater meter