Recent content by Scott Krasnigor

Happy Labor Day Weekend everyone. Cooking a 10lb brisket for the family to enjoy tonight. Using a Gator pit offset smoker. Link below.... http://saltydogbbq.duckdns.org:9080/

So far so good.Making some pulled pork today so hopefully it stays up. Still having trouble getting ddns working using duckdns but that will have to wait until another day. Thanks.

I just ran out to staples to grab another card. Will see if that helps. I figure there might be a write issue with old card. Hopefully that is all.

Nope. rPi B with standard SD card

I am having issues with the interface. I manage to get the device to boot and get into the configuration page but after a short time, I lose the web page and the following error pops up: /usr/lib/lua/luci/dispatcher.lua:211: /etc/config/luci seems to be corrupt, unable to find section 'main'...

Not sure what is going on. When I start my 4.0 HeaterMeter using model B rpi, the wifi adapter does not start all the time. Sometimes it takes me 10 tries to get ti to start up. Once it is running, it will run for a few hours then I lose the wifi connection. The main page will hang and if I...

First day of vacation and I am smoking 2 pork butts at 9lbs each. No fan issues this time. Hope it holds up. Monkeying around with PID and looks good so far. May need to tweek some more. FYI using Gator Pit offset with hickory chunks and stubbs charcoal. http://saltydogbbq.no-ip.biz:9080/

wont turn on in either manual or auto.

http://saltydogbbq.no-ip.biz:9080/ Cooking Brisket on Gator Pit offset. Of course, once I got everything set up, powered on the Heatmeter (4.0 version), the blower wouldn't turn on. Meat was prepped and fire was going so no turning back. Had to remove blower unit and reattach damper. Using...

Success! I decided to shut down/restart everything, reestablish internet connection, rescan external ip using no-ip tool, then test port access with port tester and got through. entered my remote address on phone browser and pitdroid app and received heatmeter data. Thanks for everyone's help...

Doesn't look good for upgrades. Came across this: Sadly, the EA2700 does not have the capability of being upgraded to open source firmware like DD-WRT, Tomato, or OpenWRT due to the Marvell chipset. Of course I am using the EA2700 as my router. This was written about 9 months ago so maybe...

yep. I will dig deeper into the linksys support/forums/manual when I get a chance. I don't want to flash new firmware at the moment. Preparing for dinner party tomorrow and will be smoking about 20lbs pork butt and don't want to risk having local network issues.

Inside my LAN is no issue. I can use Pitdroid and browser no problem. I have wifi disabled on phone so I can test remote connection. Nat loopback is not disabled.

I originally set the static IP via the config page on the heatmeter. After I read your post I went to the router and did a MAC-based DHCP to assign it the ip address as you suggested. The port forward table is straight forward I assigned 9080 to the external port field, 80 to the internal field...

Having issues setting up remote access to heatmeter. I followed instructions I found on various posts but no joy. I have a cable modem with linksys wireless router connected to it. I set up a DDNS with no-ip. I set up port forwarding on the router, port 9080 external to 80 internal to the...