Bryan
I tried a new SD card loaded with v14 and everything seems to work. I then upgraded using the webui to v15. I think i'm back in business. Thanks for the help.
Mike
The Pi is a model B ver 2.0. Light status is only a solid red (pwr) light. If I switch the sd card to the one with rasparian loaded and reboot the lights flash as you indicated. Same happens while attached to the Heatermeter board. Should I try a new sd card or could I have installed it...
My Heater Meter ver 4.2.4 has works great for the last year. But recently I have not been able to connect to my wifi. I have removed the Pi and it with the attached Ralink RT 5370 adapter work fine. I've tried reloading the firmware and resetting the HM. The resetting doesn't seem to do...
Thanks for the info. I calculated the S-H parms by using an online calculator. Inputs were three resistance values at known temps. Near freezing. near boiling and room temp. The resulting parms didn't give accurate temp readings...
I added a MF52-103 thermistor across probe 3 jack to sense ambient temp but it reads 185 degrees at room temp. I have the resistance set to 10000. Any suggestions?