Recent content by Mark Rusty

No I didn't take any pictures during the process but it was very easy. Hardest part was cutting the firebox because all I had was a grinder which instead of a round hole I have a square hole. It works :)

Actually it was very easy if you are handy. Requires a small hole drilled through the control panel for the valve stem (Knob) and a bigger hole through the firebox and heat shield to fit the burner tube (grinder). You can either order the manifold for the S-470 from online vendor or order the...

After 6 years all the igniters failed and decided to replace rather than keep lighting them manually. I found out Weber changed the design and now instead of replacing just the igniters you have to change the whole manifold! The good news is that I always wanted the sear burner and ended up...