Recent content by JVisser

So is there a setting that I need to change ?

Steve, what do you suggest for the fan settings ?

I played with the fan last night on the table and the damper seems to work. When I set the temperature below around 100 degrees the servo opened and moved but when I put it at 225 it closed up and the fan ran at the 50% so I think that there is something wrong with my fan / damper servo settings...

I believe that it was working properly but I am fairly new to using this device so I am not 100 % sure. The imgur site says that it is overloaded so I can't down load. Some of the issues I have had is after I start the charcoal it will die out after about 15 minutes and I am guessing that it is...

I have a Primo LG300 bbq and a heatermeter that is causing me some grief. When I plug the damper / fan the damper goes fully closed just sitting on the counter so you know what it is doing to my charcoal. I do not know how to attach pictures so if someone could help me out I will send a picture...

HI Ken, which thread is better for these set up questions ? Also, where are you going to actually change the settings ?

I just bought a ready built HM but have alot of questions. Does anyone have PID settings for a Primo LG300 bbq, how do I change the time to be the real time, how do I save my graphs. I have run two tests and each time the the temperature goes over and under the set point of 225 by 10-15 degrees...