Recent content by Dave Robson

I'm using the blower specified in the BOM. The pit probe is center rear on top of the grill held with the bracket it came with. Thanks Ralph, I've set the "On at Max Only" and see how my next cook goes. I just got a roll of Nomex gasket in the mail so I can seal everything better and...

So I'm confused. I made the changes suggested and lit the charcoal using alcohol soaked cotton and the temperature came up nicely and stabilized. After I put the chicken on at around 15:00 the temperature started cycling widely, almost 50 degrees. I bumped the temperature up so I could eat by...

Thanks for the suggestions, I'll do another test roast today and try them out. Dave!

Live graph is at http://64.231.224.237/luci for some reason it's not resolving my web address but that's another issue.

I'm sorry but I've read the wiki and the other posts on PID tuning and I still don't get it. I just did my first overnight low and slow and this is what i got: [/URL][/IMG] I have a King-griller, Heatermeter 4.0 and Ralph's rotodamper. Initial settings were B=4 (can't find any reference for...

I have my 4.0 up and running and have used it for a few cooks. I'll have the fan and rotodamper wired in by the weekend.

I have a Belkin N600 running DD-WRT and have never had a problem connecting anywhere in my yard and I've connected to my router using my tablet at my next door neighbors so I don't believe it's an issue with my router. Now today I'm grilling with the HeaterMeter and I'm connected no problem but...

I know there are a lot of variables but I was wondering what people are experiencing for WiFi range on their HeaterMeter? My router is about 6 feet off the floor and less than 3 feet from an exterior wall . My grill is about 15 feet from the exterior wall, so about 18 feet straight line to the...

email sent. Thanks for looking into this for me Bryan. Now I can stop obsessing about it and get my rotodamper wired up :) Dave!

It's a WS-1912-IT that I got at Canadian Tire, but I ordered a rain sensor TX32U-IT directly from LaCrosse and it works with the weather station. I did get a Qual:0 at one point but it didn't link up.

Yes there's a a 78mm grey wire soldered into the board. https://www.flickr.com/photos/31312887@N04/14393029436/ I moved the whole unit to the window where the sensor is so there's just glass separating them and the signal is -9. So it sounds like the module is functioning it's just not getting...

The image doesn't seem to be showing up in the post, here's the link: https://www.flickr.com/photos/31312887@N04/14414534072

I apologize if this has been covered but I've been searching for an hour and can't find a solution. I've just finished assembling my HM 4.0 and am trying to get an ambient temperature reading from my La Crosse weather station. It looks like it's seeing the transmitter but it's not reading the...