Clicked on HeaterMeter tab...
HeaterMeter serial communication can not be established. Configuration requires bidirectional serial operation. Possible causes of failure:
No HeaterMeter board attached
No HeaterMeter (AVR) firmware installed. See AVR Firmware
Incorrect baud rate in...
Ok I have tried reformating SD card over and over. I am now able to get my rPi A+ online and with access to my network. Still no connection to HM. I have tried the following....
1. LinkMeter tab
2. Click on AVR Firmware
3. Online repository
4. Flash version 4.x...
Ralph I got into the web interface and got ---. I tried getting into configuration and it's asking for a password. Played around a bit and got to the config...I think. Reflashed and got this error.
Stopping LinkMeter OK
LinkMeter platform is BCM2708
AVR fuses ffd705 OK...
Ralph I'm using an rPi A+. I reimaged my sd card and got the rPi running. Got a green flashing light and wifi dongle is flashing. Still no luck with the HM. I do see HM when I search for signals on my computer. I saw in your comment that your A+ would not load the HM. What did you do to get...
Sorry it was 3.2 at the regulator. I'll go back and check all the grounds.....UGHHHHHH I just wish this thing would work. On spring break and my back yard should be full of smoke!
Spring Break is finally here for me. I got around to tracing the board and found some wrong voltages. I did go back and check all voltage regulators to make sure they were in the correct spot. I am adding two pictures in hopes of finding a solution. Thanks for your help.
[/IMG]
[/IMG]
Ralph thanks for your help. I checked IC4 and found that the MCP1700 was in the correct spot. I do not have another probe jack for the Thermocouple Probe Jack. I will be cleaning with alcohol tonight and trying to restart again tomorrow.
I built an HM 4.3 and am having difficulty powering up. My initial power up resulted in only the Green and Yellow LED's lighting up. The LCD did not show anything except the contrast lines. I went back through and reflowed all solder points looking for cold solder points. Tried restarting and...
Hi All!!!
My name is Bryon and I'm freezing in MN.
I have built myself an Ugly Drum smoker and loving it. I am currently building a Heatemeter for the Ugly. I've run into a problem. Only my Green and Yellow lights will turn on and nothing shows on display. I will be heading to the correct...