-
-
BBPratt replied to the thread Looking for recommendations on grill brushes..I burn the crud off. Sometimes I will push a hunk of ice around while the grill is hot to wash off the cooking grids. After doing those...
-
BBPratt replied to the thread Remove stuck manifold screws Genesis 1000.Welcome the manifold bolts on the Genesis Silver/Gold series are not an issue. Weber uses stainless bolts in through holes. Either they...
-
BBPratt replied to the thread 200 grills need to be saved from the scrap yard in Northern Virginia!!!!!.I get big collections of metal stuff on a regular basis. The highest value is usually scrap metal once someone is ready to part with it...
-
Bhttps://www.weber.com/US/en/blog/burning-questions/can-i-take-my-grill-to-another-country/weber-30242.html
-
BBPratt replied to the thread Weber grills on GLP.Hi Leo, would you send a grill from the US to Brazil? I would check the shipping cost vs buying a grill locally
-
BNot 100% sure. Cannot find it listed anywhere. The E315 has 3 burners totaling about ~24k BTUs (8k per burner). Doing the math, I get ~...
-
BHello everyone, I just registered here but have been reading for 25? years. Hell, I might have even registered 20 years ago. I am...
-
BBPratt replied to the thread Genesis 1000 end caps.I pinch the bolt head with channel locks or pump pliers with one hand and remove the nut with a 7/16” socket on a impact driver
-
BIf the nuts are the stamped steel variety, I have found that inserting a small screwdriver in between the bolt head and the endcap is...
-
BBPratt replied to the thread Weber Genesis Silver restoration project.That is true. You can install new burners by removing the manifold and leaving the 2 screws in question in place. Just clean up the area...
-
BBPratt replied to the thread Weber grill pan damaged from Easy Off Heavy Duty?.I just scrape the stainless pans. They are usually stained and discolored and won’t go back to a factory state.
-
BBPratt replied to the thread Weber grill pan damaged from Easy Off Heavy Duty?.I’ve been using this easy off for porcelain enamel and fancy SS like 304 or 316 with good results. Definitely not on aluminum badges...
-
-
BBPratt replied to the thread Weber Summit 470 low heat.Hi Zac, Did you verify the temperature with another device? Do you have blue flames with yellow tips? Could be a few things: Dirty...
-
BBPratt replied to the thread Looking for Genesis NG valves.Thank you for the pictures. You need valves from a round manifold Silver A, B or C Or You can replace the manifold assembly with a...
-
BBPratt replied to the thread Looking for Genesis NG valves.Hi Dave, the Silver A has two types of manifolds - square and round. The valves are constructed differently for the manifolds. Best to...
-
-
Loading…
-
Loading…
