Sorry to be spamming but been trying and getting nowhere. One last piece of info is that I haven't soldered the LEDs yet, because I was waiting for the case to print. Not sure if this would impact anything? I doubt it.
At this point I might just have to buy another board and resolder everything...
I had components I ordered before that I had laying around. Wondering if maybe I have the wrong resonator ? I bought this one
www.taydaelectronics.com/ceramic-resonator-16-0mhz-3-pins.html
Checked continuity like you suggested and resolderes the pins. Still nothing
Thank you. I measured as follows:
RST= 2.8V
VCC=3.3V
AVC=3.3V
There's not continuity between MOS/MIS/SCK/G25/3V3/GND pins, however strangely enough there also isn't continuity between the two 3V3 pins on the rPi header. Any ideas?
I have soldered the board, but when I turn it on and go to LinkMeter, I get the following error:
Stopping LinkMeter OK
LinkMeter platform is BCM2708
Loading SPI modules...
AVR fuses ERROR
Starting LinkMeter OK
Attached are the pictures of the boards, and I can't seem to find the problem. I...