Search results


 
  1. A

    Linkmeter AVR fuses ERROR

    Yes, at least on the ATMEGA pins and rPi pins I did.
  2. A

    Linkmeter AVR fuses ERROR

    Sorry to be spamming but been trying and getting nowhere. One last piece of info is that I haven't soldered the LEDs yet, because I was waiting for the case to print. Not sure if this would impact anything? I doubt it. At this point I might just have to buy another board and resolder everything...
  3. A

    Linkmeter AVR fuses ERROR

    I had components I ordered before that I had laying around. Wondering if maybe I have the wrong resonator ? I bought this one www.taydaelectronics.com/ceramic-resonator-16-0mhz-3-pins.html Checked continuity like you suggested and resolderes the pins. Still nothing
  4. A

    Linkmeter AVR fuses ERROR

    Is there a way to test the atmega or ceramic oscillator? Maybe it's one of those two?
  5. A

    Linkmeter AVR fuses ERROR

    Thank you. I measured as follows: RST= 2.8V VCC=3.3V AVC=3.3V There's not continuity between MOS/MIS/SCK/G25/3V3/GND pins, however strangely enough there also isn't continuity between the two 3V3 pins on the rPi header. Any ideas?
  6. A

    Linkmeter AVR fuses ERROR

    I have soldered the board, but when I turn it on and go to LinkMeter, I get the following error: Stopping LinkMeter OK LinkMeter platform is BCM2708 Loading SPI modules... AVR fuses ERROR Starting LinkMeter OK Attached are the pictures of the boards, and I can't seem to find the problem. I...

 

Back
Top