Recent content by Aaron

Thanks for all of the information guys. I really appreciate it. When I purchased the Thermocouple, I didn't even realize that there were isolated vs grounded types. When I was testing yesterday, I had the other probes right next to (and in one test attached to) the end of the Thermocouple...

I'm running a new 4.2.4 board. The Thermocouple is from Auber Instruments. It's the 6' K-type with a washer probe. I have it plugged directly into the Heatermeter. No Cat 5 cable. http://www.auberins.com/index.php?main_page=product_info&cPath=20_3&products_id=307

I've done 4 cooks so far with my Heatermeter with the Rotodamper. So far, everything seems to work great, and my egg stays with +/- 3 degrees of the set point. However, I realized everything was getting done a lot faster than before, and I found an issue with my Thermocouple readings..... My...

I finished my first Heatermeter last week. I used it 3 times over the weekend. It works great! I wanted to say thanks for all of the work that you guys have done in developing this project! Also, I wanted to thank Ralph for printing a case and a damper for me! It works a million times better...

Ok..... Please disregard my previous post. I figured it out. After checking everything over, 1 pin on the AT Mega (for the servo) folded under the chip instead of making contact in the socket.

Servo Problems- Resolved... Good afternoon! I just finished building a 4.2.4 Heatermeter. Most of the items are working - probes, thermocouple, blower, etc. However, I cannot get the Tower MG90s servo working. When I first plug in the servo, it blips about 5 degrees counterclock wise, then it...