I built the heatermeter yesterday.
wrote the image to the card and nothing. Did some searching and found out that the PNY card I had purchased was not compatible. Went and returned it and got a sandisk that was.
Wrote the image and all was golden!
Connected at the default address 192.168.200.1 and went in and changed the ip address to 192.168.2.100, all was good again running on wired ethernet.
I was following this thread http://tvwbb.com/showthread.php?38671-HOWTO-Configuring-LinkMeter-WiFi&highlight=configuration and
I changed something in the network settings and I cannot get connected to the HM.
So far I've:
reset config with button
burned image to sd card
formatted and burned image to sd card again, (when I formatted it showed 8gb available on a 16gb card, I assume there is a hidden partition that I can't get to??
How do I blow away all the changes I've made so I can get back to my first boot up with 192.168.200.1?
I don't have a usb keyboard to connect and edit directly.
Thanks,
John
wrote the image to the card and nothing. Did some searching and found out that the PNY card I had purchased was not compatible. Went and returned it and got a sandisk that was.
Wrote the image and all was golden!
Connected at the default address 192.168.200.1 and went in and changed the ip address to 192.168.2.100, all was good again running on wired ethernet.
I was following this thread http://tvwbb.com/showthread.php?38671-HOWTO-Configuring-LinkMeter-WiFi&highlight=configuration and
I changed something in the network settings and I cannot get connected to the HM.
So far I've:
reset config with button
burned image to sd card
formatted and burned image to sd card again, (when I formatted it showed 8gb available on a 16gb card, I assume there is a hidden partition that I can't get to??
How do I blow away all the changes I've made so I can get back to my first boot up with 192.168.200.1?
I don't have a usb keyboard to connect and edit directly.
Thanks,
John