Bryan Mayland
TVWBB Hall of Fame
Probably the quickest thing to check is to set the HeaterMeter to Resistance mode to see what they are reading.Dennis C
Probe 0 is getting a Temp reading
Probe 1,2,3 show as OFF (not disabled)
Fan is spinning
Any ideas about the probes?
-- Go to the Linkmeter Configuration page
-- For the "Set Point" change it to "R" (no number, just the letter R.
-- Leave the field and click the "Update URL" to set sp=R
-- Go back to the Home page
-- The probes should now read their raw resistance.
If they still say OFF, check your probe header without the probe jack harness connected. Pins 3,4,5 should read 5V with respect to Pin 1 (GND). If you reattach the probe jack harness and can get a reading the voltage should drop (this can be tricky to find a place to read from, I use the little holes on the side of the header). If it does not, then check your wiring on the jacks or make sure the probe plugs aren't going in to far and not making contact or something.
If your probes now show numbers (the Maverick probes read about 220000 at room temperature) then sounds like your Steinhart coefficients aren't right. Go back to the config page and reset them using the preset list.