Temperature probe custom curve

[Ken Ba]

I would like to reuse the probes from my no-longer used CyberQ controller.

I have tried all the pre-made adjustment curves on the configuration page, and none has any effect on the temperature reading--the probe reads about 80F low.


edit: stupid user error. after I changed the curve selection from one type to another, I failed to click "save and reload". I was merely reloading the page instead of saving the new selection.

so the CyberQ probes are correct with the ET-735 curve.


for future reference, though, is there a guide to creating a custom curve?

thanks

ken

 

[Bryan Mayland]

This was just asked recently:

calculating thermistor coefficients

I'd like to use an inkbird probe as the pit probe. I can see the latest snapshot firmware includes them, but Byrans comment suggests they aren't accurate over 200F [www] Adds support for Inkbird thermistor probes used in models IBT-2X, IBT-4XS, IBT-6X. I calibrated one of these from 45F to...

tvwbb.com