New HeaterMeter v4.2.4 build - No thermocouple inserted, reading 21 degrees F


 
R

RyanGlasspoole

New member
Hey guys, have a 4.0, put together a 4.2 today with thermocouple support. I don't actually have a thermocouple probe, but on boot up instead of displaying no pit probe, it instead displays a temperature of 21 degrees f. This isn't normal, right? When I get the thermocouple probe I'll see if it shows the correct temperature.

Thanks,
Ryan
 
Did you set the probe type to Thermocouple with 5 mv/C?

You can also try sticking a piece of wire into the jack to short it out and it should read ambient temperature.
 
Set the probe type, now reading no pit probe as expected. Thanks, I think that's it. I'll have my actual thermocouple probe this evening I can test with. Thanks.
 
You must log in or register to reply here.

 

Back
Top