Auto-save not working?


 
P

Phillip P

TVWBB Fan
I'm not sure if this goes hand in hand with my past history of the HM losing my stored archives, but today I had to reboot the machine once re-associating it with my home network. I had taken it on the road for a bit and hooked it up to a couple of different access points and had to get things right for today's cook.

I got everything set up via ethernet, had to leave the house for a couple of hours, came home and realized that I had never rebooted to switch back over to wi-fi. Following the re-boot, the graph started over from scratch.

My archives are all there (new SD card fixed that a couple of weeks ago), but today's graph is lost in the ether.

Any suggestions as to why?
 
You can look and see if the autobackup is happening by looking at /root/autobackup.rrd's file time. If that's there then it could be because the time is wrong at restore time. It will only use the autobackup if the last point in the backup is earlier than the current time.
 
That would probably do it.

I'm guessing the time was wrong and once it rebooted and got ahold of an NTS, everything went bye bye.
 
You must log in or register to reply here.

 

Back
Top