Search results

You might be able to seal it up, but I am not sure jb weld is food safe. :)

The probes are fine if you don't totally submerge them, I just wedge mine in between the lid of my crock pot lid so it's not fully in the bath and it seems to be fine.

Yeah, I figured as much. That is going to be a huge usability upgrade for me so I will tough it out. I upgraded all the packages on mine with opkg and it seems to be humming right along. The only thing I can think of that would be cool (aside from the eventual sysupgrade) is the ability to...

FWIW, The mounting mechanism the Auber uses, when combined with the gasket is perfect in my opinion. You'd be hard pressed to accidentally dislodge it during normal operation.

Bryan, you said that the next version is going to have sysupgrade support.. That's likely to take another full imaging to enable right? Aka, if that's not too far off I should just wait to avoid having to crack my case back open?

I use the Auber blower on my 18" WSM, I just cut up an RCA cable I had laying around and spliced it onto the Auber.

Bam! That did it. My block device was actually mmcblk0p4, but now I see the backup. Thanks!

Hm. I figured as much so I logged in before I posted last night and I've got no subdirs in /mnt (and subsequently nothing mounted). When I used opkg to install parted I did see it complain about not being able to rm something in /tmp as it was a directory and not a file, but other than that it...

Sweet, thanks Bryan! Is there a way to verify that the backup is happening w/o having it hooked up to a display? I upgraded those packages and the firmware w/o issue, but I don't normally have this thing hooked up to a display.

I fired my sous vide setup up again for the first time in a while with your settings.. huge difference!

Heh, that sounds like a lesson I'm glad you learned screwing around and not the hard way. :)

Bryan, you need to create a new thread that talks about your brew setup (or link me to one), it looks really cool!

Hey, I didn't say it would be easy, after all you asked for thoughts on how it could be better. ;)

How enabling us to toggle between multiple network profiles via the 4-way? :)

I've built two, one 3.x linksys build and a 4.0.

Oh I see how it is, Bryan is keeping the secret of the daylight readable displays to himself.

Updated without issue, thanks Bryan!

Successful upgrade! Nice job Bryan.

Right, but that means having to crack open the 3d printed case I have to swap the cards out. I could hook it up to the network, let it grab a DHCP address and update the WiFi config faster than I could open and close it..

Great tip! I hadn't thought about just turning tethering on my phone on when I do remote cooks. It's certainly easier than having to hook up wired to a router to reconfigure the WiFi, and then having to do it all over again when I get home.