Search results

Bryan, sent you a PM if you want to poke around in my Hm and see if you see the fault.

Has been working for about 2 weeks, before it quit yesterday. Good thing is it's back to working, not sure were the problem was but it is solved now.

Solved reheated all solder joints on board reseated the chips, imaged mem card display now working

The frist thing I did was adjust the pot. I have tried powering both ways> I am waiting on card to be re-imaged then will reload it all and try again.

did it then when to alarm tabs and got this /usr/lib/lua/luci/dispatcher.lua:448: Failed to execute cbi dispatcher target for entry '/admin/lm/alarms'. The called action terminated with an exception: /usr/lib/lua/luci/cbi.lua:75: Model 'linkmeter/alarms' not found! stack traceback: [C]: in...

Thanks, already using the ribbon cable. I think have plenty of room in my case.

I plugged it in to the HM board.

Bryan, So this display you linked to on ebay works correctly with no further code mod? Hope so I just ordered one.

OK got into the with cable connection, HM is running fine So is my display hosed, or IC3 fried ?

removed my Raspberrypi but plugged in 12 power by mistake. I don't have the regulator installed for stand alone Now the display only show solid white boxes on the top row. Looks like I cant get into the rspi anymore too. Bad day working on this. ?????? Any Ideas

Thanks for your great support, I trashed my setup trying to do the msmtprc edits. The editor will be great.

@ RJ Where did you get the 4 line display?

Bryan, According to wiki MSMTP Configuration The mail transfer agent "msmtp" must be configured before any of the sendmail (email/SMS) commands will work. Edit /etc/msmtprc with the information appropriate for your mail server. How Do I edit this. HOW to set this up for Hotmail SMTP over...

Bought the Acrylic at home depot, ordered Weldon 3 acrylic cement from amazon applied glue using small syringe and needle from the drug store(very small needle), glue is sucked in by capillary reaction. Mounted boards with 4-40 screws and nylon standoffs, mounted back plate with 1/4-20 screws...

First time working with gluing acrylic. I got a few bubbles in the mounts. Might take it apart again and heat polish all the mounts to make the cut end clear. I screwed up first case lid when I glued the display mount in as one solid piece and had major bubbles is it, I just changed the case...

Yet to do first smoke still have to get a blower. It will replace my IQ and 3 wireless thermometers. Water Proof Case from Big Five sporting goods, all mounted with screws on removable in acrylic back board. sealed other than power and probe jacks

I had to re-image Mem card and put in new settings as it got confused and would not allow any access, on boot it would not display any IP address. OK the reason for the port forwarding is for access from, my cell or any place I have web access. I removed the DMZ and left port forwarding for...

Ok got back in but looks also put it in DMZ so think it might be port forwarding issues in my router I have port 80 opened up and 118 to 124 open. What do i need forwarded to it? Is it safe in DMZ?

I am port forwarding just port 80 not on dmz. do i need additional port set up?

rebooted it, correct it as you see fit I don't know much about networking