Search results

Alright I'll try this it out tomorrow! Is it normal I get 5.16V on the bs170 pin and servo pin though?

Everything is default. Should I change something?

Thanks for taking the time to help me out! GND and Gate Pin of Q5 gives me 5.16V @ 0% and 5.20V @ 100%. I went through all the installation over and I have no idea where to look at now. The only thing I could think of is that I had to buy new bs170 because I messed up the first time...

Not moving at all. I get ~4.96V on the HM board from GND to Servo. I changed the Q5 bs170 twice... I get ~4.86V from GND to Servo on the cat5 jack at the end of the servo. Is that correct?

I tried with a MG90s, not working. I tried changing the 1k resistor... nothing My board might be damaged from my poor soldering skills... When I changed the BS170 I might have damaged the circuit around the joints. I'll keep on looking.

Thanks for the tip. I just got a mg90s so I'll try this tonight

Hey guys, I just made a Heatermeter 4.3! Everything is working except the servo.. :confused: I was hoping some of you could give me a hand troubleshooting my issue. Raspberry Pi 3 B Power Supply (Same brand as suggested) 2A Servo MG90D Blower 15cfm (works properly) I know the MG90D is working...

Just made myself a beautiful Heatermeter, but had a few questions. Might aswell say hi to the community and conversate! Cheers