Search results

This is my setting for my 22.5 with burner and RD3 B=0; P=4; I=0.02; D=5 Fan pulse; min 10%; max 30%; max at startup might be worth a try.

Very nice!!

We use to use 2 batteries per buoy called 12 volt longpacks. They where 10"across by36" high and had 100's of D cell's in them, weighed 95 pounds and would run the 12 volt buoy lite for a year and where changed out each winter with lots of life left in them. We would run old car radios off 1 for...

I wonder if this jack problem is similar to some of the temp probe jacks....ie...being just a tad longer than some of the others. I remember there being a problem I think last year when some new probes where introduced, the jacks where just that much longer and if pushed all the way into the...

Looks like the Cat5 jack has some solder bridges, try reflowing there.

I would reflow all your solder points without adding more solder to the iron tip, this may remove a short if there. Then clean the board with a small brush and rubbing alcohol.

guess B isn't used anymore.........as for my vents, all bowl vents closed, top all the way open.

What does "many holes" mean as how many and what size are they? Here's my settings I use on my WSM22.5 with copper burner under charcoal grate, 3/4" copper with Rotodamper. B=0; P=4; I=0.02; D=5 Fan pulse; min 10%; max 30%; max at startup Servo 700 - 2110 inverted

Awesome job!!

this just worked for me..........change the channel your router is on, usually channel 6, to anything from 1 to 11. Mine was 6 changed to 11 and we're good to go!!

Back in business!!!!! had to reset modem earlier and now we see the HM...........Thanks all for your help!! should add, we changed the channel modem was on incase of conflict with neighbours, soon as I did that got a new IP on HM and boom it connected!

did reset, edited config, get ip addy on lcd but can't bring up its page. tried going through webui but when I type in the 192.168.200.1 no page comes up. even with hm showing ip the heatmeter.com/devises list nothing found

I had to get a new modem, so I went with a new wireless from my provider, cause my old desktop which was acting as my access died. Now I can't connect to my heatmeter, I followed the hints listed here, even started with SD formatted and new flash. I get an IP addy on the heatmeter but nothing...

Looks like a winner to me, might want to keep an eye on the o-ring incase the heat melts it.....maybe.

I don't think it's do-able.

The best person to ask would be the developer.

I may be wrong, but I don't think you can add length to probes unless you use extra wire made just for probes. Regular wire will not work.

[/IMG] make any changes in here

You'd still have water getting in by way of display, push buttons and jacks.

Your ATMega is soldered to the board?, I might be wrong but I thought all builds used a socket for it.