Bryan Mayland's latest activity

  • Bryan Mayland
    Bryan Mayland replied to the thread Trouble with Pit Probe 0.
    Awesome, great troubleshooting Mike, and glad you got it working before I even was able to see this thread. Go go community!
  • Bryan Mayland
    Bryan Mayland reacted to MikeMcW's post in the thread Trouble with Pit Probe 0 with Like Like.
    I just completed some also i'm not the best at troubleshooting electronics but from your pics it looks like you don't have the 100k or...
  • Bryan Mayland
    Bryan Mayland replied to the thread What is this?.
    It is telling you there's excessive noise detected on that probe. Red would indicate a virtually unusable signal. If you're logged in...
  • Bryan Mayland
    The defaults are designed for a BGE Large, which is what I have and do all the testing on. The PIDs were developed for blower-only, but...
  • Bryan Mayland
    I've never seen an ADC go bad before. Did you check the configuration in the webui to see if the probe configs just got scrambled...
  • Bryan Mayland
    Bryan Mayland replied to the thread Library for Eagle 6.x?.
    You can just copy paste them from the HeaterMeter schematic into your design or into your own library, but here's the whole library.
  • Bryan Mayland
    I don't think PitDroid has any configuration items in it. You just go to the webui with a browser and change them, use whatever the IP...
  • Bryan Mayland
    Yup, just set "Fan on above" to something higher than 0%, and "Servo fully open at" to something lower than 100%. You can overlap them...
  • Bryan Mayland
    Ah-ha! I thought that when I posted at first but didn't think to mention it because that code was so old and you had referenced the...
  • Bryan Mayland
    Bryan Mayland reacted to J Halvo's post in the thread HM 4.2.4 3D Printed Case with Like Like.
    An FYI for those looking for a case for a HM 4.2 with Raspberry Pi Zero W (RPi Zero W); the 2line-TC-Rpi-A+ or 2line-probe-Rpi-A+ cases...
  • Bryan Mayland
    It was in manual mode 0% with a 4.3.3 HeaterMeter with the Pi hooked up and booted and running for about 5 minutes. I have no idea why...
  • Bryan Mayland
    I just verified with my scope to be sure, constant 50Hz signal, as expected.
    • DS1Z_QuickPrint1.png
  • Bryan Mayland
    Bryan Mayland replied to the thread Quarantine Rib Cook.
    Eh I decided to just let the user decide if it is too much information at once. Snapshot 20200329 you can select "Show Fan/Servo" from...
  • Bryan Mayland
    Bryan Mayland replied to the thread Quarantine Rib Cook.
    It would be nice but the problem is that fan and servo are both filled graphs, so one will be on top of the other and it is very...
    • 1585499953745.png
  • Bryan Mayland
    It is probably the same as all the other ceramic grills. Just get a piece of sheet metal from the hardware store that's big enough to...

Top