Jonathan Hulsman
New member
I am getting ready to get a pellet grill and was thinking that if the there was a way to make the servo pin on/off control, the heater meter would work well for a pellet grill.
I am not good at software, but the heatermeter could be used to drive SSRs for the fan and auger.
Basically the servo be set to 100% when greater than 0, and this drive the fan, and the auger is driven by the fan using the 100% min option. PIDs would obviously have to be adjusted but I was wondering how difficult that modification to the code would be, and if there are other people interested.
I am not good at software, but the heatermeter could be used to drive SSRs for the fan and auger.
Basically the servo be set to 100% when greater than 0, and this drive the fan, and the auger is driven by the fan using the 100% min option. PIDs would obviously have to be adjusted but I was wondering how difficult that modification to the code would be, and if there are other people interested.