For Labor Day I cooked my first pork butt for pulled pork. It was just a small 3.5lb boneless since it was just for my wife and me (and kids, but they don't eat anything). It took 9 hours and was very good, but I don't feel it was smokey enough. There was only about a 1/8" smoke ring.
Here was my method:
1) I trimmed excess fat, put oil on the butt, covered it with rub, and put in the fridge the night before.
2) After starting the charcoal using the Minion Method I took the butt out of the fridge and added some more rub.
3) I buried 3 chunks of wood in the unlit coal and added 3 more to the top of the lit coal.
4) Put the butt on and started smoking.
5) I left the top vent 100% open the whole time as people recommend.
6) I kept the temp at 230-250 the whole time, adjusting the bottom vents accordingly. I didn't have any problem regulating the temp and didn't have to add any more charcoal.
As for the smoke:
1) For the first hour there was a lot of smoke. It was usually even leaking out around the access door and between the levels.
2) Then the smoke started to die down. I have found this in my limited experience. To get it going again I usually open the access door and turn the wood chunks a bit which starts the smoke coming again. The worry I have is that this also kicks up some ash which can get on the meat.
3) I find I have to periodically do this every 20-30 minutes to keep the smoke coming.
4) After the wood chunks were mostly gone I added 3 more chunks and later a few more smaller pieces.
I'm looking for some suggestions for getting more smoke to penetrate the meat. I have read that cold meat works better but mine was not out of the fridge very long before going into the smoker. Should I use more wood to start? Should I just add more wood when the smoke dies down rather than stirring the current chunks? It seems like lots of people run the smoker all night without playing with the wood.
My wife commented that the meat had a nice very subtle smoke flavor, but I wasn't going for subtle, I wanted serious smoke flavor!
Here was my method:
1) I trimmed excess fat, put oil on the butt, covered it with rub, and put in the fridge the night before.
2) After starting the charcoal using the Minion Method I took the butt out of the fridge and added some more rub.
3) I buried 3 chunks of wood in the unlit coal and added 3 more to the top of the lit coal.
4) Put the butt on and started smoking.
5) I left the top vent 100% open the whole time as people recommend.
6) I kept the temp at 230-250 the whole time, adjusting the bottom vents accordingly. I didn't have any problem regulating the temp and didn't have to add any more charcoal.
As for the smoke:
1) For the first hour there was a lot of smoke. It was usually even leaking out around the access door and between the levels.
2) Then the smoke started to die down. I have found this in my limited experience. To get it going again I usually open the access door and turn the wood chunks a bit which starts the smoke coming again. The worry I have is that this also kicks up some ash which can get on the meat.
3) I find I have to periodically do this every 20-30 minutes to keep the smoke coming.
4) After the wood chunks were mostly gone I added 3 more chunks and later a few more smaller pieces.
I'm looking for some suggestions for getting more smoke to penetrate the meat. I have read that cold meat works better but mine was not out of the fridge very long before going into the smoker. Should I use more wood to start? Should I just add more wood when the smoke dies down rather than stirring the current chunks? It seems like lots of people run the smoker all night without playing with the wood.
My wife commented that the meat had a nice very subtle smoke flavor, but I wasn't going for subtle, I wanted serious smoke flavor!