Kevin Scott
New member
I purchased a set of the Maverick ET-732 Food and Pit probes and just hooked them up. My LinkMeter is sitting on my Kitchen table and has a ET-72 probe in the ambient jack. The Ambient probe is reading a steady 78.3 degrees. The pit probe (ET-732 - Probe 0) is cycling through different values starting at 76.3 then it jumps to 76.7 for a couple of seconds, then it jumps to 77.2, then 77.7 then 78.1 then 78.5 then 79.0. It then reverses, moving down through the same temps in sequence until its gets to 76.3 and the the it starts all over again...
I am seeing the same behavior on the ET-732 food probe in the probe 1 jack. It is also cycling through basically the same values (slight difference).
The probe cables are extended (mostly) and you can only see this on the web interface. The LCD reads steady values for each of the probes.
Does this seem right?
I am seeing the same behavior on the ET-732 food probe in the probe 1 jack. It is also cycling through basically the same values (slight difference).
The probe cables are extended (mostly) and you can only see this on the web interface. The LCD reads steady values for each of the probes.
Does this seem right?
Last edited: