Search results

Mine is off right now but I know this (HeaterMeter Information Version 20150531B) came from the main Configuration page. The rest of the info I posted was under something like System > Administration (guess).

Thanks for the detailed response. I took your advice and used the snapshot version. This worked perfectly!

I am sure I am missing it, but is there a "how to" on here that describes the process to upgrade the HM? Are there any steps to take before upgrading? Here are the relevant menus that I see. Am I missing anything? System > Backup/Flash Firmware: Download Backup - do this prior to upgrading...

I am very happy with mine and my first brisket is in the near future! I think it will be an overnighter after I get a few more HM cooks under my belt. They did a great job didn't they!

Thanks John. I bought the Auber that goes straight to an alligator clip. Hopefully that works well. My first RD3ed cook went very well yesterday. I did a reverse ramp - I set it to 225f for the first 5 hours and then I bumped it up to 260f to speed things up. Switching to 260f over shot by 10f...

Thanks for the quick reply Ralph! I had a ribeye coming off of my Hasty Bake that I had to take care of before I could get back to you :) Thanks for the tips on the 3D print lip, I will try what you suggested. I have to admit that I am waaay more careful with these items since I can't run down...

I would like to say thanks to all that have contributed to this project. There are a few obvious people as well as countless others! Thanks so much, this is truly awesome! That said, I owe a thanks to John Bostwick. He helped build my HM 4.2.4 with RD3 and Aux board. He was great to work with...

Thanks Bryan!

Thanks again. I cleaned it up.

I tried one line and it didn't work. I either didn't press hard enough or didn't extend the line long enough. Not knowing how deep I could cut, I went with scraping. I used my third hand magnifying glass to improve the pic...

Thanks Ralph! I continued to gouge in that same place to get through copper and I lost continuity! With all the work that lies ahead, I feel like I had better ask, does this look good?

Hi all, I have been interested in putting together a HM for a while now, but I have been hesitant because a lot about this process is new to me. I saw that Bryan offered some the v4.2 BROKEN PCB. The ability to get a do-over, gave me enough confidence to give it a try. So, here I am at square...

Thanks Brian, I found the one on Mouser in your links (TACTILE-4). I found the Dip28 connector was OOS. I found something that I hope to be compatible on Amazon. I got tired of hemming and hawing over all this stuff. I placed orders to get everything I need from a combination of Mouser...

Hi Peter, I have an RPI, I just bought a damaged PCB and a good PCB. Now I am following in your footsteps. I see ALPS SKQUAAA010 has been OOS at Mouser for a few weeks now. They say "Possible Replacement 688-SKRHAAE010". I have no clue if that is a good replacement or not. Where did you find...