Recent content by S ROY

For the record, I used DigiKey Part #CP-2508-ND CONN AUDIO JACK 2.5MM MONO for my Maverick probe jacks and they fit perfectly. My only gripe with them is the short collar which is going to make mounting them in my project box a little challenging (the shaft is only 2.9mm and my project box...

Yes, it is 5cfm. I also ordered a 10cfm fan the same style. There should be no need to mess with the code for the fan. It should run any 12vdc fan right out of the box.

No changes to fan code. It is very responsive a few minutes is a fair assessment.

Finally finished up mounting it in the project box. It is up and running. Now all I have to figure out is how I am going to mount the Blower.

Thanks Bob, this will help anybody else who want to take on this project to get up and running quickly. Once again thanks for all your help.

I am using switchcraft DC Power Connectors Pwr Plug Sealed IP68 2.5mm from mouser (761KS12). I will use this on power in and out. I have not decided on how I will mount it yet.

I went back and edited my post I got all four of the probes working with a little editing in the code. It is working very well. I will have to wait a little longer because I decided to order some locking power plugs for the power supply and the blower. So that they can be solidly plugged in...

I have it completely up and running. I just need to install it in the hobby box to finish it up. Yes I know about dd-wrt just have not had the need for any more than the oem firmware.

Yes it worked without a hitch. I am using a Linksys WRT54G version 2.2 router with the latest WRT54GL firmware Ver.4.30.14. Check Here to see if there are any compatibility issues with your router / AP. Can you borrow another router / AP to try to rule this out. Also try installing the most...

Once I finally reread the comments at the top of Bobs code; I realized that I did not edit the apps-config file to make WISERVER active and deselect WEBSERVER. Also go into the WISHIELD LIBRARY AND EDIT spi.h file comment out reference to #define USE_DIG0_INTR and un-comment USE_DIG8_INTR. Move...

I figured it out. 99.9 percent of my problems were user error and failure to read the instructions carefully the other .1 the (Keepalive) was info that was not included in this post or on Bob's web page. I found the solution posted by Bob on another forum by sure coincidence. I am on my way to...

Hey john frank were you able to give those patched files a try.

Thanks for the heads up Curt Timmerman

Wow my blowers just showed up I had no idea they were this small. I ordered the one that Bob suggests in his instructions which is 5cfm and a little larger 10cfm one.

@ john frank, I have bad news and some good news. The bad news. If you lose connection for more than a 1 minuet this is not the solution for the situation. I set my AP on a timer killed it for 15 minuets while I was asleep last night. When I woke up this AM the Arduino had not recovered or...