Recent content by Nathan J

Looks like the connection issue was indeed related to the parts not being fully seated. I need to do more testing to be sure, but it appears that it is keeping a solid connection. 1st cook went great! Thanks to everyone, especially RalphTrimble, for helping to troubleshoot!

I have been searching and that seems to be the most common culprit. I was constantly in and out of it while troubleshooting. I've got a pork butt on the UDS now but after this cook I'll probably pull everything a part and try to do a clean sweep to get everything happy again. Besides not...

So if I unplug the usb wireless adapter and immediately plug it back in, the HM will come back online. No need to to reboot the HM. Wonder if this is an issue with the rPi.

New issue I'm trying to figure out...it seems like the HM times out on the network. The blue light in the edimax goes solid blue and the Web interface becomes non responsive. Seems to happen on the hard wired connection too. Other devices on the network seem to be fine...gonna have to keep...

Ahh, I didn't think of cooks away from home. What's the model number for your adapter? To be sure I understand this correctly, the HM will boot and adjust settings based on the WiFi adapter plugged in? No requirement to go into the configuration setup to adjust anything?

Lol, thanks for the heads up. I'm just trying to set it up to run consistently...I'll have to try setting the WiFi one more time into client mode. If not, will running it hardwired be a more straight forward approach for consistency?

Does it automatically switch modes once I connect to my home wifi? Or are there options in the advanced menus which allow you to use it as an AP vs Client mode?

Thank you! I followed the "No Restore" option from the wiki and that has got me back to at least the starting point where I can gain access. I ran out of time last night, but I had a weird issue where it seemed like my computer and phone would disconnect during the wifi set up process...

So I had my build go really smoothly and everything was working as designed. I did a test cook and shortly after the HM stopped connecting to the network. I thought it was a bad edimax adapter, so I bought a new one. Now I can't get any connection to the HM on my network. On the initial build...

Could you tell much of a difference between the air burner setups? What size holes are you starting with?

I'll take a board if any one has it...looking to get my hands on one.