I am curious what your probe issue was and how you fixed it. One of my probe ports requires very different calibration settings to get it to track properly. Perhaps you have a better fix.
There are definitely many setting combos that will work. I do see a couple things I think you should change and a couple you should consider changing.
On your fan settings, you have the min set to 0 but many blowers will not like very low settings. I would suggest setting the min to 5%. You...
OK, logged in to my HM...
First, the servo and fan settings. I have the servo open the damper from full closed to full open between 0%-90% PID output. From 90% to 100%, the damper stays full open and the fan comes on. Fan minimum is 5% up to 50% max in run mode and 100% at startup.
I can't...
If it means anything, I would find it helpful as well. I use the HM on different cookers and with 2 different size dampers (rd3 and rd25) and I also found the setting that work for low and slow are not best for hot cooks.
Variation of less than 10-20 degrees will not affect normal cooks and you are well under that. I wouldn’t worry too much more.
You can’t get perfect PID settings. The optimum values will change with your set point and other factors, so the important part is to find settings that will work well...
Ahhh, I get it now. Perhaps a circuit to send two different voltages (“temps”) to one of the meat probe ports depending on switch position. Something like 400+ when switch is on and less than 100 when off. Set high and low temp alarms, and use alarm scripts to change the set points when the...
You can change the setpoint with a script. That opens up all sorts of options. You can do it with an alarm script when the pit probe or a second probe it’s a target. You can add a delay so the setpoint changes 5 minutes (or whatever) after the alarm triggers. You can use a cron job to change...
Two major engineering hurdles. First is a battery that will be happy and safe at that temp. The second is transmitting and receiving a WiFi signal through a metal smoker with a reasonable range.
It is way cheaper and easier to drill a small hole so the sensor can be on the inside and the power...
I made a steel slider with a hole in it and a magnetic mount. Pops on and off in a second. The center opening is big enough for most grilling, but also slides out of the way easily. Should be able to do something similar on the BGE...
You should probaly pack the controller away in a closet for a bit and learn to use the kamado without it so you better know how to use it with the controller. I also would suggest reading some of the Pit Boss forum over at kamadoguru, especially the 2016-17 threads.
If I had to guess, you...
At 21.5” it is actually in between the LBGE (18” grate) and the XL (24” grate).
If you start with the LBGE settings you will be close. I have found different settings work better at different target temps, say 650 vs 250, but there is a wide range of settings that will work well enough.