Yeah, can you explain that like I'm 5?
So my understanding is that I would need to set this address as static on my router, but wouldn't it also have to be static on the HM as well?
I also have no idea what the subnet mask and destination IP are.
If it helps, I am using a Netgear AC1200 router.
Hey Everyone
I figured I would start a thread, as there seems to be snippets of information floating around, but not one source as to how to set up port forwarding/dynamic IPs.
First, I followed Brian's guide guide to setting up the network settings...
Thanks Ralph - I actually just bought a 3.3A power supply, and the same issue is happening. Weird thing is that it was working fine before I soldered the RCA cable to the fan. I will re-visit this, and hopefully get it running soon.
And yes, I am running HM 4.0 with the RCA jack on the Arduino...
I am not using CAT5 - just an RCA cable connected to the Rpi's bottom port, right beside the power port.
and yes, the display and lights flash just like in the video.
Setup:
HM 4.0
Stock power supply
stock fan connected to HM via RCA cable
If I hook up the fan, it's fine. If I hook up just the probes its fine. But when my fan is attached and probes are plugged in, I get the exact same issue seen in the video. This seems to be especially noticeable when I...
I have a 22" WSM that leaked out of the door and between the body and lid, so I bought the Nomex gasket kit to resolve the issue.
Still leaks out the door, but the lid is sealed now.
On the plus side, I had extra Nomex gasket, so my HeaterMeter fan seal is now great too.