Recent content by HughMcMillan

J Winn at 8:20 PM J, Thanks so much for the reply. So after every Step 6/7 failure I have understood, from another thread I read, that one had to refresh the card and add "no restore" to the end of a line so that the card would be able to be set up again. Is this true? Or can I simply hope it...

Re:Steve_M, at 8:50 PM Steve, Thanks for the suggestion. I went through my settings for my Apple AirPort Extreme (latest/current model used with a cable modem ((w/o router or WiFi)) and I looked in every setting in the AirPort Utility for "AP Isolation Mode" and found nothing. So I tried...

J. Winn, I tried your instructions but they are the same as I have been following. By the way, is an ethernet cable involved in your directions? I have had to re-flash the card as well as add "no restore" to the end of the appropriate line each and every time I do this and it is getting really...

Bryan, This looks like what I need at the moment! Can you give us a hint as to when this might be ready?

Actually Step 8 is the problematic step at the version on the following URL... http://tvwbb.com/showthread.php?38671-HOWTO-Configuring-LinkMeter-WiFi&highlight=lost+wifi I can never get to Step 9 on either a Mac or PC.

Dave, Thanks for the reply. Initially my problem was in Step 6-> Step 7 of the link you copied. I had earlier written Step 8 but it was really after Step 6 where one is "Waiting for changes to be applied..." I could not actually reach Step 7 where the Network/Interface tab is selected. It is a...

Auber doesn't provide any support for the HeaterMeter. They send everybody who purchases one to this forum for support. Basically I'm at your mercy...

Thanks for the help. First, I purchased the HeaterMeter from Auber Instruments as electronics are not my forte. I interpreted your instructions to be to plug an ethernet cable into the ethernet looking port/RJ45 with I/O lights. I assigned the IP address 192.168.200.2 to my computer in its...

I am trying to configure my HeaterMeter to work over my WiFi network. Upon reaching Step 8 of the "Configuring LinkMeter WiFi" wiki, and while "waiting for changes to be applied...", my WiFi connection to the HeaterMeter is dropped and I am placed back on my home WiFi network. I have repeatedly...