Recent content by Hank H

George l, Howdy; I was able to order 3 of the inlet disks from Weber's online store. Didn't cost much and shipping was very reasonable. Had them in about a week. hank

Howdy All; Here a chart that gives the Standard dimentions for your drums. Stock pots get ridduclious over 32 qt... http://unitechofalaska.com/store/page38.html hank

Frank H, Howdy; I live in a fifth-wheel RV. I can pack everything except the Smoky Joe into the soup can with a thyroid condition. That inclues, Craycort CI grates, cake pan (heat diffuser), 2 cooking grates, and a Cast Iron Dtch oven (yep, I can cook with the Dutch oven in there as well)...

Howdy All; I'd just use one of these....; http://www.walmart.com/ip/Lodge-10-1-2-Cast-Iron-Griddle/5969629?findingMethod=rr hank

, Howdy; Will do so sir... urrp, it still IS ... :) .

Howdy All; Thanks for the recommendations... So, basicly, I'm lookin' at 2 hours per pound at 250* to 275*. RG, Howdy; Yea, this thing took off like a rocket when I did the burn-in, Loaded with Lump (RO), did a 'minion' start, left the bottom and top vents wide open .... shot right up to 475*...

Howdy All; Finally got a burn done in my Mini... yea!!!! Now I'd like to do a Boston Butt (aka shoulder roast Blade IN), Would someone be kind enough to give me some idea of temps and time to do ... say, a 6 pounder...? Thanks much, hank

Howdy All; Question ... Why not use the rack with handles for the lower and the one without handles for the upper, as you could handle it easier up top...? hank

J Hoke, Howdy; Sounds like ya gotta plan... Happy Smokin' :wsm: hank

Chris, Howdy ; Thanks for the info. Even if they are Temp. out of Stock. :( Strange, it reads Jumbo Joe Gold ... yet it has a bottom vent with ash pan ... annnnnd dosen't appear to have the side vents ... ????? hank

Neil Robinson, Howdy; First, Welcome to the forum..... Looks like you are jumping in with both feet. I'm also building a 'Mini', so I'll look forword to the answers you get. hank

TJMartin, Howdy; Maybe the first question to you would have been, How many folks are going to be there? Then you could see how many racks you would need, then see how large of a shoe spoon or shoehorn you'd need to fit them all (the ribs, not the folks), into the mini??? I know I'm chiming in...

Bob Mann, Howdy; Did you maybe get a 'kink' in the wire ??? Do an ohm check an see if the value jumps around when you move the wire. hank

Steve_A (Tatoosh), Howdy; The IMUSA pots are made in China, They may be available there in the PI... Get some all-thread and the appropeate number of washers and nuts to connect the layers ??????? Only suggestions. hank

A Dunn, Howdy; From Mount Pleasant. Welcome to the forum. Lots an lots of info here. Kinda gettin back into the outdoor cookin' routines after several (more than 10), years away... :( Everyone's been helpful and informative.. BUT ... ya gotta ask they ain't mind readers. :) hank