Recent content by Dennis T

Great video, I think you did a great job with it.

Thank you! I will be trying to run my kamado same way and this will definitely help me!

Bryan what pid did you use?

I got IC4 and B170 installed today and all is looking good! Next is making the Micro Damper adapter and learning how to to properly run with Pit Boss K24. Steve_M @ Thank you for pointing me in the right direction!

Sorry, I probably did not explain all the events correctly. After I found ic4 in b170 location, I swapped them. With 3.3v in place I was able to flash the ATMEGA. The backlight for LCD was flickering and around IC4 a little smoke came out (did not clean up after soldering it). I removed the...

It looks like I toasted BS170 the closest to screen and messed up the traces @ IC4 which will require some bridging. Do you guys think anything else could be bad due to those 2 originally incorrectly installed? So far the symptom is just flickering screen, but when I tested the Micro Damper the...

OMG, that is the mistake I made. I will swap and see what's the verdict! thank you a lot! edit: booted up and flashed AVR but screen flickering intermittently, will look more tomorrow.

So, first of all thank you guys for this great project and for the great forum! I just finished my first HM 4.2 but it's not going as planed. At initial start up it failed, screen flickering and no LED lights at all. Found that I was getting 14 VDC (normal) and 3 to 4 VDC at IC1 (expecting...