Recent content by BradShifflett

did the tests and from the ICSP to the RPI I am getting 00.6 ohms. I tried checking from RPI G25 to ATmega and get OL on my reading, no Ohms readings, I put power into unit and I get 3.3V on the ATmega Pin 1. From ICSP to all other pins on RPI connector come up OL same as going to ATmega chip...

Pin 1 on the ATmega is the bottom right correct? the pin closest to the Probe 4? Excuse me for the dumb question, but how do I "test the circled pin on the ICSP header to see if the trace is shorting to any of the other pins on the RPi connector (do this test without the Pi connected)." Set...

I have built the heatermeter, but it is not flashing the chip. Booting up the device the Raspberry Pi is starting up, I am getting black squares on the LCD, but I have tried to run the AVRupdate and get the FUSE error I believe it is. Researching I found that to run tests with the multimeter, I...