Fan set to on at max only, but still running at 30%


 

D Peart

TVWBB Pro
Hmm, I used to know how to use this thing, but can't figure it out anymore.

I have the fan set to on at max only, max 35%, max startup 35%, pulse mode

I don't have servo set to either invert or full open/closed.

I thought this is how you were supposed to set it up so that the fan only ran at 100%, but that doesn't seem to be the case anymore. How do I get the fan to run at max only?

thanks,
david
 
I noticed same problem with mine but never asked about it. I first noticed it happened about two or three software updates ago. Seems to be just short pulses of fan log enough I would see it on the HM home page.

The fan settings are very confusing as the way it is on the web page, I think there was a discussion a while back on asking Brian to change the interface to be more user friendly as a lot of people are confused by it, hope it's on Brians ToDo list.
 
Last edited:

 

Back
Top