Downloaded the img software for my Pi Zero with header from heatermeter.com/dl.
Used the recommended img writing software to write the img to a 32gb SD card.
Put the card in the Pi reader slot.
Applied power.
And this is what I got...
Any suggestions?
Tom
PS: Says I can't post attachments. ***?
Anyway... the three LEDS come on, but the screen has a row of square boxes across the entire width and the buttons don't respond except that the bottom one turns on and off the red led.
*** is with the "No attachments" thing????
PPS: The Nanny software censor here blanked out the letters W and T and F? Really?
Used the recommended img writing software to write the img to a 32gb SD card.
Put the card in the Pi reader slot.
Applied power.
And this is what I got...
Any suggestions?
Tom
PS: Says I can't post attachments. ***?
Anyway... the three LEDS come on, but the screen has a row of square boxes across the entire width and the buttons don't respond except that the bottom one turns on and off the red led.
*** is with the "No attachments" thing????
PPS: The Nanny software censor here blanked out the letters W and T and F? Really?