Hello Everyone,
I have been looking for some guidance when it comes to adjusting the PID on my Heatermeter. I have found these instructions : https://github.com/CapnBry/HeaterMeter/wiki/PID-Tuning
I have made several adjustments, but I still cannot seem to get my pit to not overshoot after door opens. Currently I am over shooting anywhere from 15 to 30 degrees and it takes quite a while for it to come back to down to 225.
My Current settings are: PID Output Parameters
Proportional 2, Integral 0.001, Derivative 5
With that said after it settles down to 225 it is on rails. I just want as little overshoot as possible.
I have been looking for some guidance when it comes to adjusting the PID on my Heatermeter. I have found these instructions : https://github.com/CapnBry/HeaterMeter/wiki/PID-Tuning
I have made several adjustments, but I still cannot seem to get my pit to not overshoot after door opens. Currently I am over shooting anywhere from 15 to 30 degrees and it takes quite a while for it to come back to down to 225.
My Current settings are: PID Output Parameters
Proportional 2, Integral 0.001, Derivative 5
With that said after it settles down to 225 it is on rails. I just want as little overshoot as possible.
Last edited: