Hey guys,
I pulled the trigger and got the HM 4.3, with Raspberry pi 3b.. got it presoldered ( Im not good with soldering electronics).. Put it all together. Put the image of v14 on the SD card. When I load it up, it loads fine.. says "no pit probe"... when I plug in a probe it gives me temp. However, when I try and access it over the WIFI through the HM/devices page, it has two things. One which says br-Lan, and one that says ethernet wired. The far right of the page, under both of those say "testing" for some seconds then goes and says "timeout". However, if I plug the ethernet directly from my xfinity router, the br-lan is accesible, and I can see the temp graph. Any ideas what is going on? I am really hoping to be able to use this as a temp probe for the Fourth of July
Thanks in advance,
Steve
I pulled the trigger and got the HM 4.3, with Raspberry pi 3b.. got it presoldered ( Im not good with soldering electronics).. Put it all together. Put the image of v14 on the SD card. When I load it up, it loads fine.. says "no pit probe"... when I plug in a probe it gives me temp. However, when I try and access it over the WIFI through the HM/devices page, it has two things. One which says br-Lan, and one that says ethernet wired. The far right of the page, under both of those say "testing" for some seconds then goes and says "timeout". However, if I plug the ethernet directly from my xfinity router, the br-lan is accesible, and I can see the temp graph. Any ideas what is going on? I am really hoping to be able to use this as a temp probe for the Fourth of July
Thanks in advance,
Steve