I know there are many of these posts out there but I haven't seen one with a solution to my issue. The problem I have is even at 0% in manual mode, ~8.8v is being output to the fan. I've gone through this post https://tvwbb.com/showthread.php?70400-2nd-Build-Fan-running-100&p=775338&viewfull=1#post775338 and confirmed that i don't have a short anywhere.
My fan settings are: Fan output Voltage on above 0% min 0% max 100% startup max 100%.
I've looked at my board and I can't find a short anywhere. I've attached photos in case someone has better eyes for spotting that kind of stuff. The RJ45 contacts look a bit messy because of the poking and prodding with my multi-meter. Any help is appreciated!
https://goo.gl/photos/GesHn6hfPJzhgUhi6
https://goo.gl/photos/xFLvspFakzx5GLpX8
My fan settings are: Fan output Voltage on above 0% min 0% max 100% startup max 100%.
I've looked at my board and I can't find a short anywhere. I've attached photos in case someone has better eyes for spotting that kind of stuff. The RJ45 contacts look a bit messy because of the poking and prodding with my multi-meter. Any help is appreciated!
https://goo.gl/photos/GesHn6hfPJzhgUhi6
https://goo.gl/photos/xFLvspFakzx5GLpX8