Michael Kennedy
New member
Hello! I'm a new member to the Forum - and just finished my first HM build (v4.3.3, v13 firmware). I'm having some issues when testing out the RPi (A+) married to the base board.
The HM connects to my network A-OK, and OpenWrt loads fine. But I get the dreaded "OK" status under the "Available" Column on http://heatermeter.com/devices/
I can log in, using the IP address shown. When I click on the LinkMeter tab>Configuration, I receive an error (see image)
"This page contains the following errors:
error on line 126 at column 43: Input is not proper UTF-8, indicate encoding !
Bytes: 0x08 0x04 0x02 0x08
Below is a rendering of the page up to the first error."
I've tried re-flashing the AVR, as well as a complete re-imaging of the MicroSD card with a clean "noconfig" write. Unfortunately, I still get the error. Flummoxed.
Any ideas? Is there any chance this could be a solder/hardware issue?
Thank you!
The HM connects to my network A-OK, and OpenWrt loads fine. But I get the dreaded "OK" status under the "Available" Column on http://heatermeter.com/devices/
I can log in, using the IP address shown. When I click on the LinkMeter tab>Configuration, I receive an error (see image)
"This page contains the following errors:
error on line 126 at column 43: Input is not proper UTF-8, indicate encoding !
Bytes: 0x08 0x04 0x02 0x08
Below is a rendering of the page up to the first error."
I've tried re-flashing the AVR, as well as a complete re-imaging of the MicroSD card with a clean "noconfig" write. Unfortunately, I still get the error. Flummoxed.
Any ideas? Is there any chance this could be a solder/hardware issue?
Thank you!