Page 12 of 12 FirstFirst ... 2101112
Results 111 to 113 of 113

Thread: Heatermeter Aux. Thermocouple And two probe board V6.1(Final Version)

  1. #111
    TVWBB Diamond Member
    Join Date
    Apr 2013
    Location
    midwest
    Posts
    3,607
    Look at the diagram I referred to, it does NOT go to the header, goes to the switched leg(s) on the probe jacks.
    I created the Roto Damper, RD3, HMv4.2 sliding back case, "air-burner" and the "ping-pong" valve in my quest for delicious "set and forget" BBQ.

  2. #112
    New Member
    Join Date
    May 2017
    Location
    NY
    Posts
    28
    My mistake, I see that now. I think that makes it easier. Any suggestions for the best way to hide the switch and resistor, maybe a switch type I'm not thinking of?

  3. #113
    TVWBB Diamond Member
    Join Date
    Apr 2013
    Location
    midwest
    Posts
    3,607
    Hide the switch? A hidden switch that you can't flip doesn't do much good!
    If you're not going to flip the switch because you plan to only use the RDTC pit probe then just eliminate the switch and jumper from pin 7 through the 100k resistor for the pit probe... The 10K resistor can be omitted in this configuration.
    I created the Roto Damper, RD3, HMv4.2 sliding back case, "air-burner" and the "ping-pong" valve in my quest for delicious "set and forget" BBQ.

Page 12 of 12 FirstFirst ... 2101112

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •